Setting STS Parameters
The STS can be connected to the SmartLogger over RS485 or FE. If the STS is connected to the SmartLogger over RS485, you need to manually add devices and set access parameters. If the STS is connected over FE, the SmartLogger automatically identifies the STS.
Procedure
- (Optional) If the STS connects to the SmartLogger over RS485, click Add Device and set access parameters.
Parameter
Description
Device Type Set this parameter to STS.
Port number Set this parameter to the number of the COM port connected to the STS.
Address Set this parameter to the communications address of the STS.
- Choose , set device monitoring parameters and click Submit.
Tab
Function
Description
Teleindication Views the status parameters of the device, such as the switched-on or switched-off state.
N/A
Telemetering Views the real-time data of the device, such as the voltage.
N/A
Telecontrol Sets status control parameters, such as the parameter for controlling switch-on or switch-off.
Set this parameter as required.
Performance Data Views or exports the performance data of the device.
N/A
Running Param. Sets the standby signals for teleindication, telemetering, and teleadjust.
Set this parameter as required.
Active Alarm Queries active alarms.
N/A
About Queries communication information.
N/A
- Choose and set STS overtemperature protection as required.
