Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Starting an Onsite Test
Context
After an inverter is put into use, you need to periodically check its health to detect potential risks and problems.
Procedure
- Start an onsite test.Figure 7-7 Onsite test
Tab
Function
Operation Description
Inspection Check the health status of the inverter.
- If Single Inspection is selected, select the device to be inspected. If Batch Inspection is selected, you do not need to select a device.
- Set Inspection type.
- Click Start Inspection.
- Observe the progress bar and wait until the inspection is complete.
- After the inspection is successful, click Log archiving to download the inspection log.
Spot-check Start a spot-check.
NOTE:The spot-check function is available only for a device whose grid code is set to the Japanese standard.
- Select the device to be spot-checked.
- Click Start Spot-Check.
- Perform a spot-check test onsite.
- After the spot-check test is complete, click Stop Spot-Check.
Alarm Test Simulates an inverter alarm.
NOTE:Only the SUN2000-63KTL-JPH0, SUN2000-50KTL/63KTL-JPM0, and SUN2000-125KTL-JPH0 support the alarm test function.
- Choose name to select the device for which the alarm test is to be performed.
- Click an alarm name to deliver an alarm command. The alarm icon is green by default and turns red after the command is delivered.
- Click Clear Alarm to clear all alarms of the SUN2000-63KTL-JPH0, SUN2000-50KTL/63KTL-JPM0, and SUN2000-125KTL-JPH0.
NOTE:After the alarm is cleared, the SmartLogger collects alarm data again.
