Commissioning Using Deployment Wizard (V800R021C10)

Context

The deployment wizard allows you to set basic SmartLogger parameters, connect Huawei devices, power meters, and EMIs, configure Smart PCS, Huawei NMS, and third-party NMS, and implement interworking with third-party devices.

After the SmartModule communicates with the SmartLogger properly, the SmartLogger automatically identifies the SmartModule. The device name of the SmartModule is Module(M1), and the corresponding port is M1. port.

Procedure

1. Log in to the WebUI and access the deployment wizard page.
2. Set corresponding parameters as prompted. For details, see Help on the page.

   During parameter setting, click Previous, Next, or Skip as required.

   1. Set basic parameters.
      Figure 6-9 Setting basic parameters
      
   2. After Huawei devices are connected, click Search for Device to check the cable connections and allocate addresses.
      Figure 6-10 Searching for devices
      
      • During the process of Search for Device, do not perform upgrade operations (such as upgrading through the app, management system, or WebUI).
      • When you click Search for Device, cable connections (DC and AC) will be checked before device search (not applicable to third-party devices), and device addresses will be automatically allocated.
      • After the cable connection check and device search are complete, if a cable connection alarm is generated, you can click the alarm icon to view the corresponding alarm information.
      • If an alarm is generated when the cable connection check fails, click the alarm icon to view the alarm cause and handling suggestions. After the fault is rectified, check the cable connection again.
      • After the cable connection check and device search are complete, click to view the corresponding topology information.
      • After a device is added or deleted, you need to click Search for Device again in Deployment Wizard. Otherwise, the system topology will not be updated.
   3. Connect to power meters.
      Figure 6-11 Setting power meter parameters
      
   4. Connect to EMIs.
      Figure 6-12 Setting EMI parameters
      
   5. Set the battery working mode for battery control.
      Figure 6-13 Working modes
      
   6. Connect to the Huawei NMS.
      Figure 6-14 Huawei NMS
      
   7. Connect to a third-party NMS, select IEC104.
      Figure 6-15 Third-party NMS
      
   8. Connect to third-party devices.
      Figure 6-16 Third-party devices
      
   9. Complete the configuration.
      Figure 6-17 Completing the configuration