Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Connection Mode for a CPOS Interface
Context
When CPOS interfaces of a Huawei device and a non-Huawei device are connected through optical fibers or using WDM, configure the connection mode for the CPOS interface.
A router provides three connection modes: Alcatel mode, Huawei mode, and Lucent mode. Configure the mode to suit the device connected to the CPOS interface.
When the E1/T1 links on all low-end devices are aggregated to the device's CPOS interface through an SDH/SONET network, you do not need to configure the connection mode for the CPOS interface.
Procedure
- Run system-view
The system view is displayed.
- Run controller cpos cpos-number
The specified CPOS interface view is displayed.
- Run multi-channel align-mode { alcatel | huawei | lucent }
The connection mode is configured for the CPOS interface.
By default, the connection mode of a CPOS interface is Huawei.