Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Interface Status Transition Control
Context
To guarantee the network quality, disconnect the link whose quality cannot meet the standards. You can configure association between the interface status and NQA to control the interface status transition based on the detection result of the NQA test instance or NQA group.
Prerequisites
An NQA test instance has been configured. An NQA group has been created and an NQA test instance has been bound to the NQA group if the interface status transition needs to be controlled based on the detection result of the NQA group.
Procedure
- Run the system-view command to enter the system view.
- Run the interface { ethernet | gigabitethernet | xgigabitethernet } interface-number command to enter the interface view.
- Run the track { nqa admin-name test-name | nqa-group nqa-group-name } { up | down } command to configure the function
of controlling the interface status transition based on the detection
result of the NQA test instance or NQA group.
By default, the function of controlling the interface status transition based on the detection result of the NQA test instance or NQA group is disabled on a device.