Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Transmission Standard for a G.SHDSL Interface
Context
The device supports the following transmission standards:
G.991.2 Annex A and G.991.2 Annex F are North American standards.
G.991.2 Annex B and G.991.2 Annex G are European standards.
A G.SHDSL interface must use the same transmission standard as the remote G.SHDSL interface on the DSLAM.
Procedure
- Run system-view
The system view is displayed.
- Run either of the following commands to enter the G.SHDSL interface view.
- If the transmission mode is set to ATM, run:
interface atm interface-number
- If the transmission mode is set to PTM, run:
interface ethernet interface-number
- If the transmission mode is set to ATM, run:
- Run shdsl annex { a | all | b }
The transmission standard is set for the G.SHDSL interface.
By default, a G.SHDSL interface supports G.991.2 Annex A, G.991.2 Annex F, G.991.2 Annex B, and G.991.2 Annex G and can adapt to the transmission standard used by the remote G.SHDSL interface on the DSLAM.