Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VDSL Interface to Work in ATM Mode
Context
The device supports two working modes for VDSL interfaces: ATM for transmitting ATM cells and PTM for transmitting Ethernet frames.
The device functions as a CPE. A VDSL interface on the device must work in the same mode as the VDSL interface on the DSLAM.
Procedure
- Run system-view
The system view is displayed.
- Run set workmode slot slot-id vdsl atm
A VDSL interface is configured to work in ATM mode.
By default, VDSL interfaces work in PTM mode.
After running the set workmode vdsl command, you need to restart the card or device and wait for a period of time to make the configuration take effect.
