Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Working Mode for a G.SHDSL Interface
Context
The G.SHDSL interface can work in CO or CPE mode.
When two devices establish a back-to-back connection, one device must work in CO mode and the other device must work in CPE mode.
Procedure
- Run system-view
The system view is displayed.
- Run either of the following commands to enter the G.SHDSL interface view.
- If the transmission mode is set to ATM, run:
interface atm interface-number
- If the transmission mode is set to PTM, run:
interface ethernet interface-number
- If the transmission mode is set to ATM, run:
- Run shdsl mode { co | cpe }
The working mode of the G.SHDSL interface is configured.
By default, a G.SHDSL interface works in CPE mode.