Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Activating a G.SHDSL Interface
Context
After a G.SHDSL interface is deactivated, the device is disconnected from the DSLAM. To enable the G.SHDSL interface to transmit services, reactivate this G.SHDSL interface.
Procedure
- Run system-view
The system view is displayed.
- Run either of the following commands to enter the G.SHDSL
interface view.
- If the transmission mode is set to ATM, run:
interface atm interface-number
- If the transmission mode is set to PTM, run:
interface ethernet interface-number
- If the transmission mode is set to ATM, run:
- Run undo shutdown
The G.SHDSL interface is activated.
- To activate G.SHDSL interfaces bound in M-Pair mode, you only need to activate the main interface because slave interfaces will be activated together with the main interface.
- To activate G.SHDSL interfaces bound in EFM mode, activate the main and slave interfaces in sequence.
