Setting the Transmission Mode for a G.SHDSL Interface
Context
The router supports two transmission modes for G.SHDSL interfaces: ATM for transmitting ATM cells and PTM for transmitting Ethernet frames. The device functions as a CPE. a G.SHDSL interface on the device must work in the same mode as the G.SHDSL interface on the DSLAM.
Procedure
- Run system-view
The system view is displayed.
- Run set workmode slot slot-id shdsl { atm | ptm }
The transmission mode is set for G.SHDSL interfaces.
By default, a G.SHDSL interface works in ATM mode.
After completing this step, reset the G.SHDSL interface card and wait for a while for the configuration to take effect.
Each 4G.SHDSL card on the device has only one physical interface. This physical interface can be virtualized into four G.SHDSL upstream interfaces numbered from 0 to 3. After the transmission mode is set for the G.SHDSL interface card, four G.SHDSL interfaces all work in the configured mode.
