Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Port Group
Port groups can be configured to reduce interface configuration workload.
Context
To perform the same configuration on multiple Ethernet interfaces, add these Ethernet interfaces to a port group and run commands in the port group view for Ethernet interfaces. This reduces the configuration workload.
You can configure the following port groups:
- Permanent port group
- Temporary port group
If you exit from a temporary port group view, the system automatically deletes the group.
Procedure
- Configuring a permanent port group
- Run system-view
The system view is displayed.
- Run port-group port-group-name
A permanent port group is created, and the port group view is displayed.
- Run group-member { { interface-type interface-number1 | interface-type1 } [ to { interface-type interface-number2 | interface-type2 } ] } &<1-10>
An Ethernet interface is added to the permanent port group.
- Run system-view
- Configuring a temporary port group
- Run system-view
The system view is displayed.
- Run port-group group-member { { interface-type interface-number1 | interface-type1 } [ to { interface-type interface-number2 | interface-type2 } ] } &<1-10> or interface range { { interface-type interface-number1 | interface-type1 } [ to { interface-type interface-number2 | interface-type2 } ] } &<1-10>
A temporary port group is created, and the port group view is displayed.
- Run system-view