Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deactivating a G.SHDSL Interface
Context
After the device starts, its G.SHDSL interface is automatically activated. The G.SHDSL interface remains activated as long as its G.SHDSL line works properly. To enable a CPE to communicate with a DSLAM, deactivate the G.SHDSL interface on the CPE, set parameters such as the transmission standard, interface binding mode, PSD mode, and line probing function for the interface, and then reactivate this interface to make configurations take effect.
Procedure
- Run system-view
The system view is displayed.
- Run either of the following commands to enter the G.SHDSL interface view.
- If the transmission mode is set to ATM, run:
interface atm interface-number
- If the transmission mode is set to PTM, run:
interface ethernet interface-number
- If the transmission mode is set to ATM, run:
- Run shutdown
The G.SHDSL interface is deactivated.