Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the NAT Configuration
Procedure
- Run the display nat address-group [ group-index ] [ verbose ] command to check the configuration of a NAT address pool.
- Run the display nat outbound [ acl acl-number | address-group group-index | interface interface-type interface-number[.subnumber ] ] command to check the configuration of outbound NAT.
- Run the display nat static [ global global-address | inside host-address [ vpn-instance vpn-instance-name ] | interface interface-type interface-number[.subnumber ] | acl acl-number ] command to check the configuration of NAT static.
- Run the display nat static interface enable command to check whether static NAT is enabled on the interface.
- Run the display nat server [ global global-address | inside host-address [ vpn-instance vpn-instance-name ] | interface interface-type interface-number[.subnumber ] | acl acl-number ] command to check the configuration of the NAT server.
- Run the display nat mapping table { all | number } or display nat mapping table inside-address ip-address protocol protocol-name port port-number [ vpn-instance vpn-instance-name ] command to check the NAT mapping table or the number of entries in the NAT mapping table.