Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration
Procedure
- Run the display sa information command to check the SA configuration on the device.
- Run the display sa category [ category-name ] command to check the configured SA group.
- Run the display sa application-list command to check the SA protocol list on the device.
- Run the display application command to check information about applications in the system.
- Run the display application name aging-time command to check the aging time of the application association table.
- Run the display application-group command to display the information about user-defined application groups configured on the device.
- Run the display first-packet application name name command to check information about the FPI application.
- Run the display first-packet application pre-defined { dns-associated | port | protocol } command to check information about all predefined FPI applications in the system.
The protocol parameter is supported only in V300R019C11 and later versions.
- Run the display first-packet application user-defined command to check information about all user-defined FPI applications in the system.
