Configuring Basic PBX Information
This section describes how to configure basic information so that the device can work in PBX mode. Such data is used for subsequent service configuration.
- Configuring a Device to Work in PBX Mode
You can use PBX voice services after configuring the device to work in PBX mode. - Configuring Media and Signaling IP Address Pools
This section describes how to configure Ethernet IP addresses, media IP address pools, and signaling IP address pools for interfaces on the PBX, so that the PBX can connect to the IP network. - Configuring a Country Code and an Area Code
After a country code and an area code are configured, the PBX regulates calling and called numbers from different countries or areas. - Configuring an Enterprise and a DN Set
After multiple enterprises are configured on the device in PBX mode, they share the PBX. A DN set consists of an enterprise's number rules. When one enterprise shares a PBX, you do not need to configure enterprises. When one DN set meets enterprise requirements, you do not need to configure DN sets.