Setting Parameters for a SIP AG User
Context
On the IMS, a SIP AG is directly connected to a user terminal. You need to set parameters for users on the SIP AG so that the users can use services on the IMS.
Procedure
- Run:
system-view
The system view is displayed.
- Run:
voice
The voice view is displayed.
- Run:
SIP AGuser SIP AGuser-name [ port [ pots | bra ] interface-number ]
After creating a SIP AG user, set parameters for the SIP AG user, including the interface number and basic phone number associated to the SIP AG User.A SIP AG user is created and the SIP AG user view is displayed.When creating a SIP AG user, specify the interface number using the port interface-number parameter. When entering the view of an existing SIP AG user, you do not need to input the interface number.
- Run:
agid SIP AG-interface-ID
A SIP AG ID is specified for the SIP AG user.
- Run:
base-telno telno-value [ SIP AGusergroup usergroup-id ]
The basic phone number is configured for the SIP AG user.
- Set optional parameters for the SIP AG user.
Parameter
Command
Default Setting
Timeslot status
active-mask time-slot time-slot-value config-status config-status-value
This command is valid only on VE1 interfaces.
Maximum number of automatic recovery attempts from deterioration
auto-resume-limit auto-resume-limit
20
This command is valid only on VE1 and BRA interfaces.
SIP AG's capability to support the BELL ANS flag
bell-ans-flag { enable | disable }
disable
This command is valid only on FXS interfaces.
Calling number format
clip-format { sdmffsk | mdmffsk | dtmf | r15 | etsi }
FSK simple data format
Sequence in which the calling number of a SIP AG user is displayed
clip-transmission-sequence { after-ring | before-ring }
after-ring
Power-off interval
dc-time dc-time
10 ms
Single-tone ANSbar signal detection
detect-ansbar-by-single-tone { enable | disable }
disable
DSP chip input gain
dsp-input-gain dsp-input-gain
0 dB
DSP chip output gain
dsp-output-gain dsp-output-gain
0 dB
DSP template name
dsp-template dsp-template
No DSP template name configured
Service termination of a specified SIP AG user
endservice { defer [ maxcobtime maxcobtime-value ] | immediate }
By default, services of a SIP AG user are not terminated.
Extended phone number
extend-telno telno-value [ SIP AGusergroup usergroup-id ]
No extended phone number configured
FSK call display mode
fsk-mode { BELL_202 | CCITT_V23 | NTT }
BELL_202
FSK delay
fsk-time fsk-time
10 ms
User type
line-type { DEL | ECPBX | LCPBX | PayPhone }
DEL
SIP AG user priority
priority { cat1 | cat2 | cat3 }
cat3
TAS mode of CLIP
tas-pattern { NO-TAS | DT-AS }
NO-TAS
UNI fault reporting function
uni-report { enable | disable }
disable
This command is valid only on VE1 and BRA interfaces.
Voice quality enhancement (VQE) function
vqe-agc { enable | disable }
disable
Target VQE level
vqe-agc-level vqe-agc-level
13
VQE noise suppression
vqe-sns { enable | disable }
disable
Noise suppression level
vqe-sns-level vqe-sns-level
12 dB