Configuring the Device to Work in H.248 AG Mode
Context
You can configure the device to work in H.248 AG, SIP AG, or PBX mode. Before configuring H.248 AG service features, configure the device to work in H.248 AG mode. Before the configuration, run the display voice service-mode command to query the working mode of the device. If the working mode is not H.248 AG, you need to run the display current-configuration command to query the configurations and then delete all configurations in the voice view. Then, set the working mode of the device to H.248 AG. If the device is working in H.248 AG mode, ignore this configuration.
Pre-configuration Tasks
Configuring IP addresses and routing protocols for interfaces to ensure connectivity
Procedure
- Run:
system-view
The system view is displayed.
- Run:
voice
The voice view is displayed.
- Run:
service-mode h248ag
The device is configured to work in H.248 AG mode.
- Run:
quit
The system view is displayed.
- Run:
quit
The user view is displayed.
- Run:
save
The current configuration is saved.
- Run:
reboot
The device is restarted.
After the router is configured to work in H.248 AG mode, save the configuration and restart the router to make the configuration take effect.