Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an ISDN User
Procedure
- Run:
system-viewThe system view is displayed.
- Run:
voiceThe voice view is displayed.
- Run:
sigtranThe SIGTRAN view is displayed.
- Run:
iua-linkset linksetno [ mgid mgid [ jointly-work jointly-work ] | trafficmode trafficmode | pendingtime pendingtime | iid-map iid-map | braprefix braprefix | brasuffix brasuffix | praprefix praprefix | prasuffix prasuffix | cs-mode cs-mode ] *
An IUA link set is added.
- Run:
iua-link linkno linksetno localport { localipaddr | local-addr-name local-addr-name-value } remoteport remoteipaddr1 [ remoteipaddr2 remoteipaddr2 | priority priority | jointly-work-with jointly-work-with ] *
An IUA link is added.
- Run:
quitExit the voice view.
- Run:
H248aguser slotid/subcard/portid [agid agid [ terminalid terminalid linksetno linksetno interfaceid interfaceid ] * ]
The ISDN user is created and the user view is displayed.
- Run:
uni-report flag
The flag for reporting a UNI fault is set.
- Run:
auto-resume-limit limit
The maximum number of automatic recovery attempts from deterioration is set.
- Run:
power-dialer limit
The detection of malicious calling users is enabled.
