Setting Parameters for a BRA Interface

Procedure

1. Run:

   system-view

   The system view is displayed.

2. Run:

   set workmode slot slot-id bri bri-voice { nt-mode | te-mode }

   The working mode of the 2BST interface card is configured.

   When a BRA interface connects to an ISDN phone, set the working mode of the 2BST interface card to nt-mode. When a device is configured to work in SIP AG mode, the BRA interface can only connect to an ISDN phone.

   After this command is executed, the configured service is invalid.

   After you run this command, the system asks you whether to reset the 2BST interface card. If you enter Y, the system resets the 2BST interface card to make the configuration take effect. If the system does not reset the 2BST interface card, run the reset slot command to reset the 2BST interface card.

3. Run:

   voice

   The voice view is displayed.

4. Run:

   port bra slotid/subcardid/portid

   The BRA interface view is displayed.

5. (Optional) Run:

   l2-monitor enable

   BRA interface Layer 2 monitoring is enabled.

6. (Optional) Run:

   work-mode { p2p | p2mp }

   The working mode is set.

7. (Optional) Run:

   remote-power enable

   Remote power supply is enabled.

8. (Optional) Run:

   alarm enable

   The alarm function is enabled.