Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) H.248 Common Configuration
Users can configure H.248 common services based on the service requirements.
Setting RFC 2198 Parameters
Setting FAX/Modem Parameters
Context
An MG supports the fax and modem services. Related parameters
must be configured to use either service. If both services are required,
the common parameters of the two services must be configured.
Procedure
- Run:
system-viewThe system view is displayed.
- Run:
voiceThe voice view is displayed.
- Run:
fax-modem fax { is-port+2 portvalue | transmission-mode mode | flow flowvalue }
Fax parameters are set.
- Run:
fax-modem modem { eventmode eventmode | tranmode tranmode }
Modem parameters are set.
- Run:
fax-modem common { negomode negomode-value | packet-interval-10ms packet-interval-10ms-value | transevent transevent-value | vbd-codec vbd-codec-value | vbd-pt-type vbd-pt-type-value }
Common parameters are set.
