Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for Basic WLAN-Fat AP Services
Licensing Requirements
WLAN-Fat AP functions are basic functions of routers and can be obtained without licenses.
Hardware Requirements
Table 2-4 Hardware requirements
Series |
Feature Support |
|---|---|
AR300, AR600, AR700, AR1600, and AR6000 series |
Only the AR651W-X4, AR651W-8P, AR651W, AR657W, AR611W, AR611W-LTE4CN, AR617VW, AR617VW-LTE4, AR617VW-LTE4EA, and AR6120-VW provide WLAN-Fat AP functions. |
AR6000-S series |
Not supported |
Feature Limitations
- When the network bridge and WLAN-Fat AP functions are both configured on a device, IP address information obtained by STAs cannot be displayed on the device because the network bridge transparently transmit ARP packets from the STAs.
- By default, a device supporting WLAN Fat functions has a Wi-Fi network configured. The login name and password of this Wi-Fi network are PnP_xxxxxx and ARxxxxxx, respectively. xxxxxx is the last 6 digits of the device ESN. This Wi-Fi network is available only when the device has the factory defaults and allows deployment personnel to configure deployment. After a user saves the deployment configuration and restarts the device, the device automatically deletes this Wi-Fi network. To restore this Wi-Fi network, restore the device to the factory defaults. If a device has a LAN-side interface as the management interface, the user can connect to this Wi-Fi network to access the web system in V300R019C10 and later versions.