No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Enterprise
Worldwide
Huawei Global - English
Search
Support Documentation
NetEngine AR V300R019 CLI-based Configuration Guide - WLAN-FAT AP
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the STA Blacklist or Whitelist

Configuring the STA Blacklist or Whitelist

STA blacklist and whitelist functions allow authorized STAs to connect to the WLAN and reject access from unauthorized STAs.

Pre-configuration Tasks

Configuration Procedure

Configure the blacklist or whitelist function for an AP and check the configuration.

Configuring a STA Whitelist

Context

A STA whitelist contains MAC addresses of STAs that are allowed to connect to a WLAN. When only a few STAs are allowed to connect to a WLAN, configure a STA whitelist and set the STA access control mode to whitelist for an AP.

If a STA whitelist is empty, all STAs can connect to the WLAN to access network resources.

Procedure

  • Configuring a STA whitelist for AP
    1. Run system-view

      The system view is displayed.

    2. Run wlan

      The WLAN view is displayed.

    3. Run sta-whitelist mac-address

      The MAC address of a STA is added to the whitelist.

      By default, no MAC address is added to the STA whitelist.

    4. Run sta-access-mode whitelist

      The access control mode is set to the STA whitelist for the AP.

      By default, the STA access control mode is disable, indicating that STA access is not controlled by the blacklist or whitelist.

Configuring a STA Blacklist

Context

A STA blacklist contains MAC addresses of STAs that are not allowed to connect to a WLAN. When only a few STAs are not allowed to connect to a WLAN, configure a STA blacklist and set the STA access control mode to blacklist for an AP.

Procedure

  • Configuring a STA blacklist for the AP
    1. Run system-view

      The system view is displayed.

    2. Run wlan

      The WLAN view is displayed.

    3. Run sta-blacklist mac-address

      The MAC address of a STA is added to the blacklist.

      By default, no MAC address is added to the STA blacklist.

      The device supports a maximum of 128 MAC addresses.

    4. Run sta-access-mode blacklist

      The access control mode is set to the STA blacklist for the AP.

      By default, the STA access control mode is disable, indicating that STA access is not controlled by the blacklist or whitelist.

Verifying the STA Blacklist and Whitelist Configuration

Pre-configuration Tasks

After the blacklist or whitelist function is configured, you can check the STA access control mode of APs and the configured blacklist or whitelist.

Procedure

  • Run the display sta-access-mode command to check the STA access control mode of a specified AP.
  • Run the display sta-whitelist command to view the STA whitelist.
  • Run the display sta-blacklist command to view the STA blacklist.
Translation
简体中文
Download
Updated: 2021-11-30

Document ID: EDOC1100112363

Views: 45196

Downloads: 213

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Digital Signature File

Digital Signature Authentication Mode
Share
Previous Next

Copyright © 2023 Huawei Technologies Co., Ltd. All rights reserved.

You are going to visit :