Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting Controller Enclosures (When Two Controller Enclosures Are Deployed)
This section describes how to connect two controller enclosures through SO 25 Gbit/s RDMA interface modules.
Prerequisites
- You have developed a plan for connection between multiple controller enclosures. For details on how to develop a connection plan, see (Optional) Connection Planning for Multiple Controller Enclosures.
- The following installation tools and materials have been prepared:
- RDMA cables
- Diagonal pliers
- Cable ties
Procedure
- Connect controller enclosures following the connection plan, as shown in Figure 6-12.
It takes 2 minutes for the storage system to identify a new cable. Do not remove the cable during this period. If the storage system fails to identify the cable after 2 minutes, verify that the cable is in good shape and properly connected, and then reinstall the cable.
- Route the RDMA cables.
For details about how to route and bind cables, see General Cable Routing Description and Cable Routing and Bundling Basics.
