Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Stopping Synchronizing or Reversely Synchronizing a Clone Pair
This section describes how to stop data synchronization between a source LUN and a target LUN. If synchronization is stopped, the system only retains the pair relationship. When you start synchronization again, the system performs an initial synchronization.
Prerequisites
- Health Status of the clone pair is Normal.
- Running Status of the clone pair for which you want to stop synchronization is Synchronizing or Sync paused.
- Running Status of the clone pair for which you want to stop reverse synchronization is FullCopy reverse syncing, DiffCopy reverse syncing, FullCopy reverse sync paused, or DiffCopy reverse sync paused.
Procedure
- Choose Data Protection > Protection Entities > LUNs > Clone Pairs.
- Select the desired clone pair and choose Synchronize > Stop or Reverse Sync > Stop.Confirm your operation as prompted.
Alternatively, perform any of the following operations to stop synchronization or reverse synchronization for a clone pair:
- Click
on the right of the desired clone pair and select Stop Sync or Stop Reverse Sync.
- Click the name of the desired clone pair. In the upper right corner of the page that is displayed, click Operation and select Stop Sync or Stop Reverse Sync
- Choose Services > Block Service > LUNs.
- Click the name of the desired LUN. On the page that is displayed, click the Protection tab and select Clone from the drop-down list. Select the desired clone pair and choose Synchronize > Stop or Reverse Sync > Stop.
- Click the name of the desired LUN. On the page that is displayed, click the Protection tab and select Clone from the drop-down list. Click
on the right of the desired clone pair and select Stop Sync or Stop Reverse Sync.
- Choose Data Protection > Protection Entities > LUNs > LUNs.
- Click the name of the desired LUN. On the page that is displayed, click the Protection tab and select Clone from the drop-down list. Select the desired clone pair and choose Synchronize > Stop or Reverse Sync > Stop.
- Click the name of the desired LUN. On the page that is displayed, click the Protection tab and select Clone from the drop-down list. Click
on the right of the desired clone pair and select Stop Sync or Stop Reverse Sync.
- Click the value in the Clone Pairs column of the desired LUN if the value is not 0. On the Protection tab page, select Clone from the drop-down list. Select the desired clone pair and choose Synchronize > Stop or Reverse Sync > Stop.
- Click the value in the Clone Pairs column of the desired LUN if the value is not 0. On the Protection tab page, select Clone from the drop-down list. Click
on the right of the desired clone pair and select Stop Sync or Stop Reverse Sync.
- Click
on the right of the desired clone pair and select Stop Sync or Stop Reverse Sync.
on the right of the desired clone pair and select Stop Sync or Stop Reverse Sync.
on the right of the desired clone pair and select Stop Sync or Stop Reverse Sync.
on the right of the desired clone pair and select Stop Sync or Stop Reverse Sync.