Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Pausing a HyperMetro Pair
If you need to pause services at one site due to site failures or certain reasons, select the desired site. Pausing may cause data inconsistency between local and remote sites.
Prerequisites
- A HyperMetro pair is not added to a HyperMetro CG.
- Running Status of a HyperMetro pair is Normal or Synchronizing (The connection of devices is normal).
Procedure
- Choose Data Protection > Protection Entities > LUNs.
- Click the HyperMetro Pairs tab. Select the desired HyperMetro pair and click Pause.Confirm your operation as prompted.
You can also pause a HyperMetro pair as follows:
- Click
on the right of the desired HyperMetro pair and select Pause.
- Click the name of the desired HyperMetro pair. In the upper right corner of the page that is displayed, select Pause from the Operation drop-down list.
- Choose Services > Block Service > LUNs. Click the name of the desired LUN. On the page that is displayed on the right, click the Protection tab, and then select HyperMetro from the drop-down list. Select the desired HyperMetro pair and click Pause.
- Choose Data Protection > Protection Entities > LUNs > LUNs.
- Click the name of the desired LUN. On the page that is displayed on the right, click the Protection tab, and then select HyperMetro from the drop-down list. Select the desired HyperMetro pair and click Pause.
- If the value of HyperMetro Pairs is not 0, click the value. Select the desired HyperMetro pair and click Pause.
- Click
on the right of the desired HyperMetro pair and select Pause.