Check After Delivery
Check the items described in this section after HyperMetro has been configured.
Context
Table 11-1 lists the check items.
Item |
Criteria |
Method |
|---|---|---|
Both HyperMetro storage systems |
Meets the requirements in Storage Interconnection Rules. |
Use SmartKit (formerly named Toolkit) to check the items. |
Reserved space |
Meets the requirements in Storage Interconnection Rules. |
|
HyperMetro replication links |
Each controller has two or more replication links to the remote storage system. |
|
Quorum network |
|
|
HyperMetro replication ports and front-end ports connected to hosts |
These ports are physically isolated. |
|
HyperMetro LUN mapping |
Both LUNs in the HyperMetro pair are mapped to the hosts in the two DCs. |
|
Fault domain |
The active-active DCs and quorum site are in different fault domains. |
Check these items manually. |
Quorum server |
UPS is configured for the quorum server and network devices. |
Prerequisites
SmartKit is ready to use.
- For enterprise users, log in to https://support.huawei.com/enterprise/ and choose TECHNICAL SUPPORT > Product and Solution Support > Centralized Storage > Data Management and Operation > SmartKit > Software Download. Download and install the latest version.
- For carriers, log in to https://support.huawei.com/carrier/ and choose Product Support > Data Storage and Intelligent Vision > Storage Common > SmartKit. Download and install the latest version.
Procedure
- Use SmartKit to check the system. Rectify any defect according to the suggestions provided by SmartKit.
- Log in to SmartKit.
- Choose Home > Storage and click Site Deployment Quality Inspection.
- Click Device Selection. On the Select Devices page that is displayed, click Add Device, add both storage systems to the device list, and click OK.
- Click Deployment Inspection. On the Select Devices page that is displayed, click Add Device and add the hosts connected to the storage systems to the device list. Then click Next.
- When adding the storage systems, set Device Type to Storage. If HyperMetro is used on the storage systems,
will be displayed on SmartKit.
- When adding devices by IP address, you can only add one device at a time. Then click Add Device again to add the next device.
- When adding the storage systems, set Device Type to Storage. If HyperMetro is used on the storage systems,
- Check the items manually according to the deployment quality criteria and import the check results. Click Next.
- Set the check items for the storage systems and hosts at both DCs, and click Next.
It is recommended that you retain the default check items.
- Select a path for saving the inspection results and click Next.
- SmartKit starts inspection.
Some inspection items may take a long time.
- After the inspection is complete, click View the report to view the inspection report. For the failed items, rectify the faults based on the suggestions.
- Manually check the system.
will be displayed on SmartKit.