Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Pausing a HyperMetro CG
If you want to pause services in a specific period of time due to site faults or other causes, pause the HyperMetro CG of the corresponding site first.
Prerequisites
Running Status of a HyperMetro CG is Paused, Normal, Synchronizing, or To be synchronized.
Procedure
- Choose Data Protection > Protection Entities > Protection Groups.
- Click the HyperMetro CGs tab. Select the HyperMetro CG that you want to pause and click Pause.Confirm your operation as prompted.
You can also perform the following operations to pause a HyperMetro CG:
- Click
on the right of the desired HyperMetro CG and select Pause.
- Click the name of the desired HyperMetro CG. In the upper right corner of the page that is displayed, click Operation and select Pause.
- Choose Services > Block Service > LUN Groups. Click the name of the desired LUN group. On the page that is displayed on the right, click the Protection tab, and then select HyperMetro from the drop-down list. Select the desired HyperMetro CG and click Pause.
- Choose Data Protection > Protection Entities > Protection Groups > Protection Groups.
- Click the name of the desired PG. On the page that is displayed on the right, click the Protection tab, and then select HyperMetro from the drop-down list. Select the desired HyperMetro CG and click Pause.
- If the value of HyperMetro CGs is not 0, click the value. Select the desired HyperMetro CG and click Pause.
- Click
on the right of the desired HyperMetro CG and select Pause.