Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting a Serial Cable
The rear panel of the server provides a standard RJ45 serial port (three-pin serial port), which works as the system serial port by default. You can set it as the iBMC serial port using the iBMC CLI.
The serial port can be used as:
- System serial port to monitor the OS status
- iBMC serial port for debugging and fault locating
Procedure
- Wear an ESD wrist strap. For details, see ESD Protection.
- Plug the connector into the serial port. See Figure 5-22.
