Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the PXE Function of an NIC
Configuring the LOM PXE
- Access the BIOS. For details, see Accessing the BIOS.
- Press ← or → to switch to the Advanced screen, as shown in Figure 10-13.Figure 10-11 Advanced screen
- Choose LOM Configuration > PXE Configuration and press Enter.The PXE Configuration screen is displayed, as shown in Figure 10-12.
The PXE Configuration screen may vary according to the server.
- Configure the PXE function.
- Select the network port such as PXE1 Configuration, and press Enter.
- In the dialog box that is displayed, select Enable and press Enter.
- Select a network protocol for PXE boot.
- Select PXE Boot Capability and press Enter.
- In the dialog box that is displayed, select a network protocol that needs to be supported.
- UEFI: IPv4
- UEFI: IPv6
- UEFI: IPv4/IPv6
- Press F10.
The Save configuration changes and exit? dialog box is displayed.
- Select Yes and press Enter.
The server automatically restarts for the settings to take effect.
Configuring the PXE Function of a PCIe NIC
- Access the BIOS. For details, see Accessing the BIOS.
- Press ← or → to switch to the Advanced screen, as shown in Figure 10-13.
- Select Network Device List and press Enter.The Network Device List screen is displayed, as shown in Figure 10-14.
- Select the network port (such as MAC:AC:8D:34:21:2B:60) of the external NIC, and press Enter.The Network Device MAC:AC:8D:34:21:2B:60 screen is displayed, as shown in Figure 10-15.
- Select Huawei (R) Intelligent Network Interface Card and press Enter.
The Main Configuration Page screen is displayed, as shown in Figure 10-16.
- Set PXE to ENABLE.
- Press F10.
The Save configuration changes and exit? dialog box is displayed.
- Select Yes and press Enter.
The server automatically restarts for the settings to take effect.
