Removing the Air Duct
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Check whether a full-height full-length PCIe riser module is installed.
- Remove the full-height full-length PCIe riser module.
For details, see Removing a PCIe Riser Module.
- Check whether a supercapacitor is configured.
- Press the buckle to disconnect the cable between the supercapacitor and the TFM card.Figure 6-182 Removing the supercapacitor cable
- Determine the position of the air duct.
- Lift the air duct.Figure 6-183 Removing the air duct
- Place the removed component in an ESD bag.