Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the Avago SAS3004iMR PCIe RAID Control Card
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Take the spare part out of its ESD bag.
- Determine the position of the Avago SAS3004iMR RAID controller card.
- Remove the PCIe riser modules.
For details, see Removing a PCIe Riser Module.
- Install the Avago SAS3004iMR RAID controller card.
For details, see Installing a PCIe Card.
- Install the PCIe riser modules.
For details, see Installing a PCIe Riser Module.
- Install the M.2 FRU on the Avago SAS3004iMR RAID controller card.
For details, seeInstalling an M.2 FRU on the Avago SAS3004iMR PCIe RAID Controller Card .
- Install the chassis cover.
For details, see Installing the Chassis Cover.
- Install the server.
For details, see Installing a Server.
- Connect the power cables to the PSUs.
For details, see Connecting PSU Cables.
- Power on the server.
For details, see Power-On Procedure.
- Log in to the iBMC WebUI, and check whether the new component is normal.
For details, see Atlas 800 Inference Server iBMC User Guide (Model 3010).
