Removing a DIMM
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Remove the air duct or built-in drive module.
For details, see Removing the Air Duct or Removing the Built-in Drive Module.
- Determine the position of the DIMM.Figure 6-106 DIMM slots
- Remove a DIMM.
- Simultaneously press the ejectors outwards. See (1) in Figure 6-107.
- Remove the DIMM from the slot. See (2) in Figure 6-107.
- Place the removed DIMM in a DIMM box.
- Install a DIMM filler.
Perform this operation only when a DIMM is not installed immediately.