Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Battery
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Remove the screw-in RAID controller card.
For details, see Removing the Screw-in RAID Controller Card.
- Determine the position of the battery.
- Use a screwdriver to gently pry up the right end of the battery, and remove the entire battery.Figure 6-153 Removing the battery
- Place the removed component in an ESD bag.
