Removing the Right Mounting Ear Board
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Remove the air duct or built-in drive module.
For details, see Removing the Air Duct or Removing the Built-in Drive Module.
- Determine the position of the right mounting ear.
- Remove the right mounting ear.
- Pressing the connector on the mounting ear signal cable, pull out the cable vertically. See (1) in Figure 8-155.
- Loosen the screws that secure the mounting ear. See (2) in Figure 8-155.
- Pull out the right mounting ear horizontally and slowly pull out its signal cable along the chassis wall. See (3) in Figure 8-155.
- Place the removed component in an ESD bag.