Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Built-in Drive Module
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Determine the position of the built-in drive module.
- Remove all drives from the drive module.
For details, see Removing a SAS/SATA Drive.
- Remove cables from the built-in drive module.
The cable connection varies depending on the drive configuration. For details, see:
- Lift the built-in drive module.Figure 8-128 Removing the built-in drive module
- Place the removed component in an ESD bag.
