Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the DVD Drive
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Remove the air duct or built-in drive module.
For details, see Removing the Air Duct or Removing the Built-in Drive Module.
- Remove all fan modules.
For details, see Removing a Fan Module.
- Remove the fan module bracket.
- Pressing the latches on both sides of the fan module bracket, lift the fan module bracket vertically. See (1) and (2) in Figure 6-70.
- Remove the other fan module bracket in the same way.
- Determine the position of the DVD drive.
- Remove the DVD drive.
- Disconnect the cables from the DVD drive to the mainboard and the front-drive backplane. See (1) in Figure 6-71.
For details, see Server with 8 x 2.5" Drives (Pass-through) 1.
- Pressing down the plastic handle, push the DVD drive outward. See (2) and (3) in Figure 6-71.
- Disconnect the cables from the DVD drive to the mainboard and the front-drive backplane. See (1) in Figure 6-71.
- Place the removed component in an ESD bag.
