Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Right Mounting Ear
Procedure
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Remove the air duct or built-in drive module.
For details, see Removing the Air Duct or Removing the Built-in Drive Module.
- Take the spare part out of its ESD bag.
- Determine the position of the right mounting ear.
- Installing a right mounting ear
- Route the mounting ear signal cable through the chassis. See (1) in Figure 6-158.
- Install the right mounting ear. See (2) in Figure 6-158.
- Tighten the screw to secure the mounting ear. See (4) in Figure 6-158.
- Connect the signal cable to the connector of the right mounting ear on the mainboard. See (4) in Figure 6-158.
- Install the air duct or built-in drive module.
For details, see Installing the Air Duct or Installing the Built-in Drive Module.
- Install the chassis cover.
For details, see Installing the Chassis Cover.
- Install the server.
For details, see Installing a Server.
- Connect the power cables to the PSUs.
For details, see Connecting PSU Cables.
- The server starts to be powered on.
For details, see Power-On Procedure.
- Check the indicators on the right mounting ear for fault.
For details, see Front Panel Indicators and Buttons.
