Ports on the Rear Panel

1

(Optional) 10GE optical port (LOM port 1)

2

(Optional) 10GE optical port (LOM port 2)

3

(Optional) 10GE electrical port (LOM port 1)

4

(Optional) 10GE electrical port (LOM port 2)

5

VGA port

6

GE electrical port (LOM port 1)

7

GE electrical port (LOM port 2)

8

Management network port

9

Serial port

10

USB 3.0 ports

11

PSU sockets

-

-

(Optional) 10GE optical port

10GE SFP+

2

10GE LOM service ports (optical). Use the optical or electrical ports based on service requirements.

(Optional) 10GE electrical port

10GE BASE-T

2

10GE LOM service ports (electrical). Use the optical or electrical ports based on service requirements.

GE electrical port

1000BASE-T

2

GE LOM service ports (electrical).

VGA port

DB15

1

Used to connect a display terminal, such as a monitor or KVM.

Serial port

RJ45

1

Default operating system serial port used for debugging. You can also set it as the iBMC serial port by using the iBMC command.

Management network port

1000BASE-T

1

Used for server management.

USB port

USB 3.0

2

Used to connect to a USB device.

PSU socket

-

2

Used to connect to the power distribution unit (PDU) in the cabinet. You can select the number of power supply units (PSUs) as required.

X722

10GE optical port

Auto-negotiation 10,000 Mbit/s (full duplex)

10,000 Mbit/s

10/100/1000 Mbit/s

10GE electrical port

Auto-negotiation 1000 Mbit/s (full duplex)

1000 Mbit/s

10/100 Mbit/s

Auto-negotiation 10,000 Mbit/s (full duplex)

10,000 Mbit/s

10/100 Mbit/s

GE electrical port

Auto-negotiation 1000 Mbit/s (full duplex)

1000 Mbit/s

10/100 Mbit/s

• Use the Computing Product Compatibility Checker to obtain information about the cables and optical modules supported by the LOM ports.
• The LOM ports support NC-SI, WOL, and PXE.
• The LOM ports do not support forced rates.
• The electrical LOM ports cannot be connected to power over Ethernet (PoE) devices (such as a switch with PoE enabled). Connecting a LOM port to a PoE device may cause link communication failure or even damage the NIC.
• The electrical LOM ports do not support SR-IOV.
• Forcibly powering off a server will cause intermittent NC-SI disconnection and disable the Wake on LAN (WOL) function of the LOM ports. To restore the NC-SI connection, refresh the iBMC WebUI.