Installing the Screw-in RAID Controller Card

Procedure

1. Power off the server.

   For details, see Power-Off Procedure.

2. Remove the power cables from the PSUs.

   For details, see Removing PSU Cables.

3. Remove the server.

   For details, see Removing the Server.

4. Place the server on the ESD workstation.
5. Remove the chassis cover.

   For details, see Removing the Chassis Cover.

6. Determine whether a built-in drive module is configured.
   • If yes, go to Step 7.
   • If no, go to Step 8.

7. Remove the built-in drive module.

   For details, see Removing the Built-in Drive Module.

8. Check whether I/O module 2 is configured with a full-height full-length PCIe riser module.
   • If yes, go to Step 9.
   • If no, go to Step 10.

9. Remove the PCIe riser modules.

   For details, see Removing a PCIe Riser Module.

10. Take the spare part out of its ESD bag.
11. Check whether a supercapacitor is configured.
    • If yes, go to Step 12.
    • If no, go to Step 13.

12. Install the supercapacitor.

    For details, see Installing the Supercapacitor.

13. Determine the position of the screw-in RAID controller card.
    Figure 8-75 Position of the screw-in RAID controller card
    

14. Install the RAID controller card.
    1. Insert the RAID controller card vertically into the connector on the mainboard. See (1) in Figure 8-76.
    2. Tighten the screws to secure the RAID controller card. See (2) in Figure 8-76.
    Figure 8-76 Installing a screw-in RAID controller card
    

15. Connect the cable to the RAID controller card.

    For details, see Internal Cabling.

16. Check whether I/O module 2 is configured with a full-height full-length PCIe riser module.
    • If yes, go to Step 17.
    • If no, go to Step 18.

17. Install the PCIe riser modules.

    For details, see Installing a PCIe Riser Module.

18. Determine whether a built-in drive module is configured.
    • If yes, go to Step 19.
    • If no, go to Step 20.

19. Install the built-in drive module.

    For details, see Installing the Built-in Drive Module.

20. Install the chassis cover.

    For details, see Installing the Chassis Cover.

21. Install the server.

    For details, see Installing a Server.

22. Connect the power cables to the PSUs.

    For details, see Connecting PSU Cables.

23. Power on the server.

    For details, see Power-On Procedure.

24. Log in to the iBMC WebUI, and check whether the new component is normal.

    For details, see Atlas 800 Inference Server iBMC User Guide (Model 3010).

25. Configure the RAID controller card.

    For details, see Atlas 800 AI Server RAID Controller Card User Guide (Model 3010).