Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the VGA Board
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Remove the air duct or built-in drive module.
For details, see Removing the Air Duct or Removing the Built-in Drive Module.
- Remove all fan modules.
For details, see Removing a Fan Module.
- Remove the fan module bracket.
- Pressing the latches on both sides of the fan module bracket, lift the fan module bracket vertically. See (1) and (2) in Figure 8-137.
- Remove the other fan module bracket in the same way.
- Remove the VGA and DVD drive cables from the mainboard and front-drive backplane.
For details, see Internal Cabling.
- Remove the bracket.
- Pull the bolt that secures the bracket. See (1) in Figure 8-138.
- Push out the bracket horizontally. See (2) in Figure 8-138.
- Determine the position of the VGA board.
- Remove the VGA board.
- Remove the cables from the VGA board.
- Loosen the screws that secure the VGA board. See (1) in Figure 8-139.
- Remove the VGA board horizontally. See (2) in Figure 8-139.
- Place the removed component in an ESD bag.
