Installing the Built-in Drive Module
Procedure
- Power off the server.
For details, see Power-Off Procedure.
- Remove the power cables from the PSUs.
For details, see Removing PSU Cables.
- Remove the server.
For details, see Removing the Server.
- Place the server on the ESD workstation.
- Remove the chassis cover.
For details, see Removing the Chassis Cover.
- Take the spare part out of its ESD bag.
- Determine the position of the built-in drive module.
- Push the plastic latch in the arrow direction on each side of the chassis, and place the built-in drive module downwards. See (1) and (2) in Figure 6-131.
- Install built-in drives.
For details, see Installing a SAS/SATA Drive.
- Connect cables to the built-in drive module.
The cable connection varies depending on the drive configuration. For details, see:
- Install the chassis cover.
For details, see Installing the Chassis Cover.
- Install the server.
For details, see Installing a Server.
- Connect the power cables to the PSUs.
For details, see Connecting PSU Cables.
- Power on the server.
For details, see Power-On Procedure.
- Log in to the iBMC WebUI, and check whether the new component is normal.
For details, see Atlas 800 Inference Server iBMC User Guide (Model 3010).