No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
STS-(3000K, 6000K)-H1 Smart Transformer Station Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Connecting Cables to the UPS

(Optional) Connecting Cables to the UPS

You have obtained the UPS and its auxiliary materials. Check that the quantity and model of the following materials are correct based on the packing list.

Table 7-3 Material list

No.

Material

Code

1

Power supply unit (PSU)

02311LLC

2

Energy storage module (ESM)

01073568

3

Ground cable of the PSU (16 mm2)

25030429

4

AC input/output power cable

25030386

5

Signal cable between the UPS and the SACU

04080342

6

Power cable

04151856

7

Signal cable between the PSU and the ESM

04080441

8

Ground cable between the PSU and the ESM (10 mm2)

04151857

9

Wall mounting kit

21153226

10

Fitting bag (including terminals, labels, tubing, and cable ties)

02231YSG

Procedure

  1. Install the UPS.

    1. Install a mounting kit.
      Figure 7-21 Installing a mounting kit
    2. Move the mounting kit from the rear of an ESM to the left side, and install the ESM on the outer wall of the STS.
      Figure 7-22 Installing an ESM
    3. Install the connecting kit and combine the PSU with the ESM.
      Figure 7-23 Installing a PSU
    4. Install a connecting plate.
      Figure 7-24 Installing a connecting plate

  2. Connect a PE cable.

    Figure 7-25 Connecting a PE Cable

  3. Connect the cables between the PSU and the ESM.

    Figure 7-26 Connecting cables

  4. Connect AC power cables.

    Figure 7-27 Connecting AC power cables

  5. Move the bridgeware between 3XUPS1 terminals 3–4 to terminals 4–5 and the bridgeware between terminals 24–25 to terminals 25–26. (The 3XUPS1 wiring terminal placed in the power distribution box in the MV room.)
  6. Connect a signal cable for the SACU. Insulate the unused cable terminals and bind them in the cable holder.

    Figure 7-28 Connecting a signal cable for the SACU

Download
Updated: 2019-12-05

Document ID: EDOC1100115701

Views: 2631

Downloads: 196

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next