Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Installing an EPO Cable
- Prepare the EPO switch and cable before installation. The recommended cable size is 22 AWG.
- Equip the EPO switch with a protective cover to prevent misoperations, and protect the cable with a protective tube.
Connect the EPO button to the EPO port on the SmartLi.
Figure 5-54 Cable connection for an EPO NO port
![]()
Figure 5-55 Cable connection for an EPO NC port
![]()
- If the NC status is used, remove the jumper between NC and 12V first. When you turn off the EPO switch, EPO is triggered.
- If the NO status is used, ensure that the jumper between NC and 12V is connected. When you turn on the EPO switch, EPO is triggered.