Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Protective Parts of Enclosures
If a storage system is shipped as an integrated bay, protective parts are pre-installed for the device. These protective parts are used to protect device connectors during transportation. After the bay is installed, remove the corresponding protective parts.
Removing Front Protective Parts of a Controller Enclosure
Use a Phillips screwdriver to loosen the screws counterclockwise on the front protection parts of the controller enclosure on both sides, and remove the front protection parts.
Figure 3-62 Removing front protective parts of a controller enclosure
![]( "Click to enlarge")
Removing Positioning Blocks of a Controller Enclosure or Disk Enclosure
Figure 3-63 shows the appearance of a positioning block.
The method of removing positioning blocks for a smart disk enclosure is the same as that of removing positioning blocks for a SAS disk enclosure or controller enclosure. The following uses a smart disk enclosure as an example.
- Use a Phillips screwdriver to loosen the screw counterclockwise on the positioning block and remove the screw, as shown in Figure 3-64.
- Loossen the positioning block counterclockwise by holding its handle, and then pull out the positioning block. See steps 1 and 2 in Figure 3-65.
- Repeat 1 and 2 to remove the positioning block on the other side of the disk enclosure.
