Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Network Cable
The fiber extractor cannot be used to replace shielded network cables.
- Use a fiber extractor to remove the unshielded network cable.
- Acquire the clamping method of the fiber extractor.
Figure A-9 shows the clamping method of the fiber extractor when the fiber extractor is used to remove the unshielded network cable.
- Remove the unshielded network cable.
Align the fiber extractor with the RJ45 connector of the network cable. Clamp the connector with proper force as shown in Figure A-9, and then pull the cable outwards as shown in Figure A-10.
- Acquire the clamping method of the fiber extractor.
- Use a fiber extractor to install the unshielded network cable.
- Acquire the clamping method of the fiber extractor.
Figure A-11 shows the clamping method of the fiber extractor when the fiber extractor is used to install the unshielded network cable.
- Install the unshielded network cable.
Clamp the RJ45 connector as shown in Figure A-11. Then gently insert the connector into an Ethernet port until the clip locks the connector. (You can hear a click when the connector gets locked.)
- Acquire the clamping method of the fiber extractor.
