Viewing DR Star Trios
This section describes how to view created DR Star trios and members in them.
Context
- On the DR Star management page, you can click
to refresh DR Star trio information.
- On the DR Star management page, you can click
or
next to a parameter, and enter a keyword or select a parameter value to search for desired DR Star trios.
- On the DR Star management page, you can click
and select DR Star trio information you want to view.
to refresh DR Star trio information.
or 
next to a parameter, and enter a keyword or select a parameter value to search for desired DR Star trios.
and select DR Star trio information you want to view.Procedure
- Choose Data Protection > Protection Entities > LUNs.
- Click the DR Star Trios tab.
In the function pane, view the DR Star trio information listed in Table 6-1.
Alternatively, select one of the following methods to view the DR Star trio information:
- Choose Services > Block Service > LUNs. Click the name of the desired LUN. The LUN information is displayed on the right. Click the Protection tab, and then select DR Star from the drop-down list below.
- Choose Data Protection > Protection Entities > LUNs > LUNs. Click the name of the desired LUN. The LUN information is displayed on the right. On the Protection tab, select DR Star from the drop-down list below.
- Choose Data Protection > Protection Entities > LUNs > LUNs. If the value of DR Star Trios of the desired LUN is not 0, click the value.
Table 6-1 DR Star trio parametersParameter
Description
Name
Name of a DR Star trio.
Health Status
Indicates whether a DR Star trio works properly. Possible values are Normal, and Faulty.
Running Status
Running status of a DR Star trio. Possible values are Enabled, Disabled, and Invalid.
Local Resource
Name of the local resource.
DR Policy
DR policy for a DR Star trio.
Switchover Policy
Indicates whether to automatically switch the status of the asynchronous remote replication pairs in a DR Star trio after a fault occurs. Possible values are Automatic and Manual.
Switchover Silent Time (Minutes)
When Switchover Policy is set to Automatic, the storage system waits until Switchover Silent Time expires if a fault occurs. If the fault persists after Switchover Silent Time expires, the storage system switches the status of two asynchronous remote replication pairs. If the fault is rectified before Switchover Silent Time expires, the storage system will not perform the switchover.
NOTE:This parameter is available only when Switchover Policy is set to Automatic.
ID
ID of a DR Star trio.
