Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VRRP Group Status Changes Frequently
Procedure
- Run the display vrrp virtual-router-id command in any view to check whether the VRRP group is associated with an interface or a BFD session.
If the VRRP group is associated with an interface or a BFD session, flapping of the interface or a BFD session causes VRRP group status flapping. Rectify the fault on the associated module.
If association is not configured, go to step 2.
- Run the display vrrp virtual-router-id command in any view to check the preemption delay of the VRRP group.
If the preemption delay is 0, run the vrrp vrid virtual-router-id preempt-mode timer delay delay-value command in the view of the interface where the VRRP group is configured to configure a non-zero preemption delay.
If the preemption is not 0, go to step 3.
- Run the vrrp vrid virtual-router-id timer advertise advertise-interval command in the view of the interface where the VRRP group is configured to set a larger interval at which VRRP Advertisement packets are sent. Alternatively, run the vrrp vrid virtual-router-id preempt-mode timer delay delay-value command to set a larger preemption delay.