Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for HSB
Involved Network Elements
Other network elements are not required.
License Support
HSB is a basic feature of the device and is not under license control.
Feature Support in V200R019C10
All models of S9300 and S9300X series switches support HSB.
Feature Limitations
HSB supports backup only between two devices and requires that the model and software version of the two devices be the same.
VRRP HSB supports only the active/standby mode but not the load balancing mode.
- When configuring DHCPv6 relay on the active and standby devices, pay attention to the following points:
- Currently, only DHCPv6 prefix routing information can be backed up.
- The hsb-service-type dhcp hsb-group group-index command needs to be executed to bind DHCP services to an HSB group. Otherwise, DHCPv6 prefix routing information on the active and standby devices cannot be backed up.
- Services can be bound to an HSB group only before the HSB group is enabled.