Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Collecting VXLAN Packet Statistics
Context
If you want to check the network status or handle network faults, enable packet statistics collection in a BD and for VXLAN tunnels to view VXLAN packet statistics. The information helps you diagnose faults.
Only the LE1D2S04SEC0, LE1D2X32SEC0, LE1D2H02QEC0, X series and LE2D2X48SEC0 card support VXLAN packet statistics collection.
Procedure
- Enable statistics collection in a BD.
- Run the system-view command to enter the system view.
- Run the bridge-domain bd-id command to create a BD and enter the BD view.
- Run the statistics enable command to enable statistics collection in a BD.
By default, statistics collection is disabled in a BD.
- Enable statistics collection on VXLAN tunnel packets.
- Run the system-view command to enter the system view.
- Run the interface nve nve-number command to create an NVE interface and enter the NVE interface view.
- Run the vxlan statistics peer { peer-ip-address | peer-ipv6-address } [ vni vni-id ] enable command to enable statistics collection on VXLAN tunnel packets.
By default, statistics collection on VXLAN tunnel packets is disabled.
Follow-up Procedure
- Run the display bridge-domain bd-id statistics command to view packet statistics in the BD.
- Run the display vxlan statistics { source source-ip-address peer peer-ip-address | source source-ipv6-address peer peer-ipv6-address } [ vni vni-id ] command to view VXLAN tunnel packet statistics.