Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Common Attributes of Optical and Electrical Interfaces
- Configuring Bidirectional Flow Control
- Configuring Unidirectional Flow Control
- Setting the Minimum Interval for Re-enabling an Interface
- Configuring the Delay in Reporting Physical Status Changes
- Configuring the Interval of Collecting Traffic Statistics on an Interface
- Configuring Link Flapping Protection
- Configuring an Interface to Transit to the Error-Down State When the Number of Received Error Packets Exceeds the Threshold
- Configuring the IFG
- Configuring the Device to Count the IFG and Preamble Traffic Statistics
- Setting the Jumbo Frame Length Allowed on an Interface
- Configuring the MTU of an Interface
- Configuring the Log and Alarm Threshold for Inbound and Outbound Bandwidth Usage
- Configuring the Trap Threshold for a Sudden Traffic Volume Change on Interfaces
- Disabling Detection of a Sudden Broadcast Traffic Volume Change in the Inbound Direction of Interfaces
- Enabling the Log Function for Inbound and Outbound Packet Loss Caused by Congestion
